Zebra Technologies 2237A10L010 ユーザーズマニュアル

Applicator Interface Connector

9/6/07

IIIPlus/R110Xi/R170Xi User Guide

13383L-004 Rev. A

The Applicator Interface Assembly is available in two versions: a +5 V I/O and a 
+24–28 V I/O. 

 lists the pin configurations and functions of the applicator interface 

connector for both +5 V and +24–28 V operation.

1

I/O SIGNAL 
GROUND

(+5V Return)

I/O Signal 
Ground

Using jumper JP2, this pin can be configured as isolated 
or non-isolated from the printer signal ground. See 

 for more information.

1

I/O SIGNAL 
GROUND

(+24-28V Return)

I/O Signal 
Ground

No jumpers to configure.

Customer must provide this external 

ground. (This ground can come from pin 8 when 
operating at 28V for all printers except the 
110XiIIIPlus.) See 

 for more information.

2

+5V  I/O

(Fused at 1 A)

Replace 

the fuse only with 

one of the same 

type and rating.

Power

Using jumper JP1, this pin can be configured as isolated 
or non-isolated from the Applicator Interface Circuit 
+5 V Supply. See 

 for more information.

2

+24-28V I/O

Power

No jumpers to configure. This +24-28V power source 
also supplies voltage for output signal pull-up resistors.

Customer must provide this external 

power. (This power can come from pin 7 when 
operating at 28V for all printers except the 
110XiIIIPlus.) See 

 for more information.

3

START PRINT

Input

See 

 for more information 

about the start and end print signals.

• Pulse Mode—The label printing process begins on the 

HIGH to LOW transition of this signal if a format is 
ready. Deassert this signal HIGH to inhibit printing of 
a new label.

• Level Mode—Assert LOW to enable the printer to 

print if a label format is ready. When deasserted HIGH, 
the printer completes the label that is printing then 
stops and waits for this input to be reasserted LOW.

4

FEED

Input

When the printer is idle or has been paused, assert this 
input LOW to trigger repeated feeding of blank labels. 
Deassert HIGH to stop feeding blank labels and register 
to the top of the next label.

* Applicator boards have separate part numbers for the +5V version (49872-099M) and the +24-28V version (33361-099M).