Zebra Technologies 2237A10L010 ユーザーズマニュアル
185
Data Ports
Applicator Interface Connector
9/6/07
Xi
IIIPlus/R110Xi/R170Xi User Guide
13383L-004 Rev. A
11
END PRINT
Output
for more information
about the start and end print signals. See
for more information about the
modes.
• MODE 0—The applicator port is OFF.
• MODE 1—Asserted LOW only while the printer is
moving the label forward; otherwise deasserted HIGH.
• MODE 2—Asserted HIGH only while the printer is
moving the label forward; otherwise deasserted LOW.
• MODE 3—(Default) Asserted LOW for 20
milliseconds when a label is completed and positioned.
Not asserted during continuous printing.
Not asserted during continuous printing.
• MODE 4—Asserted HIGH for 20 milliseconds when a
label is completed and positioned. Not asserted during
continuous printing.
continuous printing.
12
MEDIA OUT
Output
Asserted LOW while there is no media in the printer.
13
RIBBON OUT
Output
Asserted LOW while there is no ribbon in the printer.
14
DATA READY
Output
for more information
about this signal.
• Asserted LOW when sufficient data has been received
to begin printing the next label.
• Deasserted HIGH whenever printing stops after the
current label, due to either a pause condition or the
absence of a label format.
absence of a label format.
15
(Non-
RFID)
SPARE
Output
To be determined.
15
(RFID)
VOID
Output
• Asserted LOW when the RFID transponder over the
antenna is “voided.”
• Deasserted HIGH when the end print signal is asserted.
Table 22 • Applicator Interface Connector Pin Configuration (Continued)
Pin
No.
Signal Name
Signal Type
Description
* Applicator boards have separate part numbers for the +5V version (49872-099M) and the +24-28V version (33361-099M).