Vanguard Managed Solutions 6455 ユーザーズマニュアル

ページ / 128
2-30 
Hardware Description
Vanguard 6455 Option Cards
Each Vanguard 6455 can support two of either the T1 or E1 version of the VoIP 
Convergence Card. You cannot, however, install one of each card version in any one 
Vanguard 6455. When cards are installed in a Vanguard 6455, interfaces are assigned 
as illustrated in Figure 2-37.
Figure 2-37. VoIP Convergence Card Interface Assignments
Note
For information regarding the mapping of ISDN interfaces, please refer to the 
Vanguard ISDN manuals (Part Numbers T0103-05 and T0103-06).
T1 and E1 Versions There are two versions of the VoIP Convergence Card, one for T1 and the other for 
E1 applications. Figure 2-38 shows the rear panel of the T1 version and Figure 2-39 
shows the rear panel of the E1 version.
Figure 2-38. VoIP Convergence Card Rear Panel: T1 Version
Figure 2-39. VoIP Convergence Card Rear Panel: E1 Version
Caution
You can install two T1 or two E1 VoIP Convergence Cards in one Vanguard 6455. 
The Vanguard 6455 does not operate correctly if you install T1 and E1 versions in 
the same unit.
The T1 version of this option card supports a maximum of 24 voice channels. The 
E1 version supports a maximum of 30 voice channels. DSP SIMM Cards must be 
installed on the VoIP Convergence Card to support voice channels. If these SIMM 
Cards are not mounted to the option card, it supports data transmission only.
T1/E1 interfaces
4 and 5
T1/E1 interfaces
6 and 7
T1 NTWK 2
T1 NTWK 1
ALARM
ALARM
E1 NTWK 2
E1 NTWK 1
ALARM-1
ALARM-2
TX-1
RX-1
RX-2
TX-2