Enterasys Networks 1G58x-09 ユーザーズマニュアル
Process Overview: Routing Protocol Configuration
Configuring OSPF
13-58
13.1.2.27show ip ospf neighbor
Use this command to display the state of communication between an OSPF router and its neighbor
routers.
routers.
show ip ospf neighbor [detail] [ip_address] [vlan vlan_id]
Backup Designated
Router id
Router id
IP address of the backup designated router on this interface,
if one exists.
if one exists.
Timer intervals
configured
configured
OSPF timer intervals. These are either default, or configured
with the ip ospf retransmit-interval (
with the ip ospf retransmit-interval (
ip ospf hello-interval (
), and the ip ospf
dead interval (
) commands. The wait
timer represents the amount of time a router waits before
initiating a designated router/backup designated router
election. The wait timer changes when the dead interval
changes. The retransmit timer represents the amount of time
between successive transmissions of LSAs (Link State
Advertisements) until acknowledgement is received.
initiating a designated router/backup designated router
election. The wait timer changes when the dead interval
changes. The retransmit timer represents the amount of time
between successive transmissions of LSAs (Link State
Advertisements) until acknowledgement is received.
Neighbor Count
Number of neighbors over this interface.
Adjacent neighbor
count
count
Number of adjacent (FULL state) neighbors over this
interface.
interface.
Adjacent with
neighbor
neighbor
IP address of the adjacent neighbor.
Table 13-4
show ip ospf interface Output Details (Continued)
Output
What It Displays...