GE GFK-1004B ユーザーズマニュアル
5
5-27
GFK-1004B
Chapter 5 The Station Manager
NODE Command
The NODE command has the form:
NODE
This command causes the TCP/IP Ethernet Interface sign-on message to be printed out
on the screen. When the TCP/IP Ethernet Interface is executing the Soft Switch Entry
Utility, the reason that the utility was entered is also displayed.
on the screen. When the TCP/IP Ethernet Interface is executing the Soft Switch Entry
Utility, the reason that the utility was entered is also displayed.
A typical NODE command is shown below:
> node
IC697 PLC Factory LAN Interface
Copyright (c) 1990-1995. All rights reserved.
PROM version 2.00 (xxAx), Software version 2.00 (xxAx)
TCP/IP Ethernet
IP address = 3.16.18.47
MAC address = <<080019010177>> MAC default = <<080019010177>>
EM7A2
OK Command
This command causes the STATUS OK LED to turn ON. It has no effect on the contents
of the exception log.
of the exception log.
The OK command has the form:
OK
A typical OK command is shown below:
= ok
Display modified
PING Command
The PING command has the form:
PING <node> [ <cnt> [ <sch> [ <len> ] ] ]
where
<node> is the Internet address of the destination.
<cnt> is the number of ICMP echo requests to send to the destination.
<sch> is the number of 10 millisecond intervals to wait for a reply from the
<cnt> is the number of ICMP echo requests to send to the destination.
<sch> is the number of 10 millisecond intervals to wait for a reply from the
destination, and send the next ICMP echo.
<len> is the length of the ICMP echo message (minimum of 8 bytes).