Vidikron 30ET ユーザーズマニュアル
Vidikron Vision 30 Series Owner’s Operating Manual
27
PRE
L
IMINAR
Y
Connecting 12-volt Trigger
Output to External Theater
Equipment
Output to External Theater
Equipment
If your home theater contains a retractable screen, screen mask or other 12-volt
trigger-activated equipment, use the cable supplied with the Vision 30 to connect it to the
12-volt trigger output as shown in Figure 3-10.
trigger-activated equipment, use the cable supplied with the Vision 30 to connect it to the
12-volt trigger output as shown in Figure 3-10.
Figure 3-10. Connecting the 12-Volt Trigger Output to Other Equipment
Connecting to AC Power
The Vision 30 ships with various
types of AC power cords. Choose the
one that is appropriate to your
locale.
types of AC power cords. Choose the
one that is appropriate to your
locale.
Plug the female end of the power
cord into the AC receptacle on the
rear of the projector (AC 100V ~
240V). Then, connect the other end
to your AC power source.
cord into the AC receptacle on the
rear of the projector (AC 100V ~
240V). Then, connect the other end
to your AC power source.
3.7
Removing the Lens Cap
Removing the Lens Cap
Press the lens latches together to remove the
lens cap. To replace the cap, push it squarely
over the lens until it snaps on.
lens cap. To replace the cap, push it squarely
over the lens until it snaps on.
S-VID /
S-VID
to other,
12-volt
trigger-activated equipment
(screen, screen mask etc.)
Red = +12V (Tip)
Black = Ground (Sleeve)
3.5-mm
mini plug
mini plug
Power
switch
switch