Vidikron 30ET ユーザーズマニュアル

1.

Turn on your source components. 

2.

Turn on the main power switch at the rear of the projector. The POWER LED lights 
orange. The LAMP and TEMP LEDs light red briefly, then go out. 

3.

Press the ON button on the remote control to turn 
on the Vision 30. The POWER LED flashes orange to 
indicate that it is warming up. 

4.

When the projector is ready for use, the POWER LED 
lights green. 

5.

“Searching...” appears on the screen before the 
Vision 30 identifies the input signal and remains 
there until a valid signal is detected. 

6.

If an incompatible input signal exceeds the range of the projector, a “No signal 
supported” message appears on the screen. This message remains on the screen until 
you change the input signal. 

The Vision 30 OSD language is initially set to English, but can also display the menus in 
French, Spanish, Italian or German. To change the OSD language:

1.

Press MENU.

2.

Select Installation from the Main Menu and press ENTER.

3.

Select Language from the Installation Menu and press ENTER.

4.

Press 

 or 

 to highlight the desired language. (The change takes effect immediately.)

By default, the Vision 30 is configured for a “floor/front” installation, in which the projector is 
installed upright and in front of the screen. If it is installed behind the screen and/or mounted 
on a ceiling, you must change the picture orientation. To do this:

1.

Press MENU on the remote control. 

2.

Select Installation from the Main Menu and press ENTER. 

3.

Select Picture Orientation from the Installation Menu and press ENTER.

4.

Choose Floor Rear, Ceiling Front or Ceiling Rear to match the installation method.

The Vision 30 gives you a great deal of control over the picture size and focus. 

Adjust the projected image size with 
the zoom ring on the lens. To focus 
the image, rotate the focus ring on 
the lens. 

Focus

Zoom out

Zoom in