Epson S1D13504 ユーザーズマニュアル
Page 4
Epson Research and Development
Vancouver Design Center
S1D13504
13504PWR Software Suspend Power Sequencing Utility
X19A-B-007-04
Issue Date: 01/02/01
Usage
PC platform: at the prompt, type
13504pwr [/software
/lcd] [/enable
/disable] [/i] [/?]
.
Embedded platform: execute
13504pwr
and at the prompt, type the command line argument.
Where:
/software
selects software suspend
/lcd
selects the LCD
/enable
activates software suspend or the LCD
/disable
deactivates software suspend or the LCD
/i
initializes registers
/?
displays this usage message
Examples
To enable software suspend mode, use the following arguments:
/software /enable
To disable software suspend mode, use the following arguments:
/software /disable
To enable the LCD, use the following arguments:
/lcd /enable
To disable the LCD, use the following arguments:
/lcd /disable
Comments
• The
/i
argument is to be used when the registers have not been previously initialized.
• The PC must not have more than 8M bytes of memory when used with the S5U13504B00B
board.
• Follow simultaneous display guidelines for correct simultaneous display operation.
• Do not use a dual panel with a CRT. Select “Panel Single” whenever using a CRT, even if a
panel is not attached. Also, the panel section of 13504CFG must be programmed to “Single
Panel.”
Panel.”
• When a CRT is enabled, the settings for the CRT will override the panel settings. If a panel is
also used, the CRT timing values will have to be changed to more closely match the panel's
timing.
timing.
• A CRT cannot show 15 or 16 bits-per-pixel.
• Do not attach a 16-bit panel when using the CRT.