Epson S1D13504 ユーザーズマニュアル
Epson Research and Development
Page 5
Vancouver Design Center
13504PWR Software Suspend Power Sequencing Utility
S1D13504
Issue Date: 01/02/01
X19A-B-007-04
Program Messages
ERROR: Unknown command line argument.
An invalid command line argument was entered. Enter a valid command line argument.
ERROR: Already selected SOFTWARE.
Command line argument
/softwar
e
was selected more than once. Select
/software
only once.
ERROR: Already selected HARDWARE.
Command line argument
/hardware
was selected more than once. Select
/hardware
only once.
ERROR: Already selected ENABLE.
Command line argument
/enable
was selected more than once. Select
/enable
only once.
ERROR: Already selected DISABLE.
Command line argument
/disable
was selected more than once. Select
/disable
only once.
ERROR: Select /software or /hardware.
Neither command line argument
/software
or
/hardware
was selected
. Select
/software
or
/hardware.
ERROR: Select /enable or /disable.
Neither command line argument
/enable
or
/disable
was selected
. Select
/enable
or
/disable
.
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL can only manage 10 devices
simultaneously.
simultaneously.
ERROR: Could not register S1D13504 device.
A 13504 device was not found at the configured addresses. Check the configuration address using
the 13504CFG configuration program.
the 13504CFG configuration program.
ERROR: Did not detect S1D13504.
The HAL was unable to read the revision code register on the S1D13504. Ensure that the S1D13504
hardware is installed and that the hardware platform has been set up correctly.
hardware is installed and that the hardware platform has been set up correctly.