HP (Hewlett-Packard) 620n ユーザーズマニュアル

Installation Procedures 11

ENWW

1. Turn off the printer and remove the printer’s power cord.

2. Identify an available HP Enhanced I/O (EIO) slot (typically, in 

the back of the printer).

For printers with multiple EIO slots, you  can install 
the print server into any EIO slot in the HP printer.

3. If the slot has a cover plate, remove it.

4. Insert the print server card. Align the card with the guide rails 

in the slot.

5. Press the card into the slot until firmly seated and tighten each 

retaining screw a little at a time until both screws are secure.

6. Connect the network cable to the card using the RJ-45 connector 

port.

7. Turn on the printer. 

RJ-45

EIOSG.book  Page 11  Thursday, October 9, 2003  1:42 PM