HP (Hewlett-Packard) 620n ユーザーズマニュアル

Installation Procedures 12

ENWW

1.  Print a Jetdirect Configuration page and check for status 

messages.

In most HP LaserJet printers, a Jetdirect Configuration page 
will automatically print when you print a Printer Configuration 
page. 

In HP DesignJet printers, Jetdirect configuration information 
will be included on the Service Configuration print.

2. In the first section of the Jetdirect Configuration Page, look for 

the status message “I/O CARD READY”.  See 

This section of the configuration page also contains product-
specific information, such as:

■

HP Jetdirect product number

■

Firmware revision number

■

LAN Hardware (MAC) address

■

Manufacturing identification number

For a description of other messages that may appear 
on the Jetdirect Configuration Page, refer to the 
applicable HP Jetdirect Administrator’s Guide 
located on the HP Jetdirect CD-ROM.

3. If I/O CARD READY appears, the card has been installed 

successfully. Proceed to 

.

If I/O CARD READY does not appear, check that you have:

■

Installed the print server correctly and properly connected the 
print server to the network

■

Verified that the network is operating properly

You can turn the printer off and then on again to reinitialize the 
print server and try again.

EIOSG.book  Page 12  Thursday, October 9, 2003  1:42 PM