DELL 8132 ユーザーズマニュアル

ページ / 1818
Data Center Bridging Commands
879
lldp dcbx version
Use the lldp dcbx version command in Global Configuration mode to 
configure the administrative version for the Data Center Bridging Capability 
Exchange (DCBX) protocol. This command enables the switch to support a 
specific version of the DCBX protocol or to detect the peer version and match 
it. DCBX can be configured to operate in IEEE mode or CEE mode or CIN 
mode. In auto mode, version detection is based on the peer device DCBX 
version. The switch operates in either IEEE or one of the legacy modes on 
each interface. 
NOTE: CIN is Cisco Intel Nuova DCBX (version 1.0). CEE is converged enhanced 
ethernet DCBX (version 1.06).
Use the no form of the command to reset the dcbx version to the default 
value of auto.
Syntax
lldp dcbx version {auto | cin | cee | ieee}
no lldp dcbx version
Parameter Description
Default Configuration
The default version is auto.
Command Mode
Global Config
Parameter
Description
auto
Automatically select the version based on the peer response.
CIN
Force the mode to Cisco-Intel-Nuova. (DCBX 1.0)
CEE
Force the mode to CEE (DCBX 1.06)
IEEE
Force the mode to IEEE 802.1Qaz 
2CSPC4.X8100-SWUM102.book  Page 879  Friday, March 15, 2013  8:56 AM