DELL 8132 ユーザーズマニュアル

FIP Snooping Commands

This command can only be entered after FIP snooping is enabled using the 

 command. Otherwise, it does not appear in the CLI 

syntax tree.

The following example enables FIP snooping on VLANs 2, 3,...8.

s1(config)#vlan 2-8

s1(config-vlan)#fip-snooping enable

Use the fip-snooping fc-map command in VLAN Configuration mode to 

configure the FP-MAP value on a VLAN. The FC map value is used to help in 

securing the switch against misconfiguration.

Valid FC map values are in the range of 0x0 to 0xffffff.

The default FC map value is 0x0efc00.

VLAN Configuration mode

When configured using fabric-provided MAC addresses, FCoE devices 

transmit frames containing the FC map value in the upper 24 bits. Only 

frames that match the configured FC map value are passed across the VLAN. 

Frames with MAC addresses that do not match the FC map value are 

discarded.

2CSPC4.X8100-SWUM102.book  Page 905  Friday, March 15, 2013  8:56 AM