DELL 8132 ユーザーズマニュアル

FIP Snooping Commands

This command can only be entered after FIP snooping is enabled using the 

 command. Otherwise, it does not appear in the CLI 

syntax tree.

The following example configures an FC map value of 0x100 on VLAN 208. 

(config)# vlan 208

(config-vlan)# fip-snooping enable

(config-vlan)# fip-snooping fc-map 0x100

To relay the FIP packets received from the hosts toward the Fibre Channel 

Fabric (FCF), the switch needs to know the interfaces to which the FCFs are 

connected. Use the fip-snooping port-mode command in Interface 

Configuration mode to configure the interface that is connected towards 

FCF. By default, an interface is configured to be a host-facing interface if it is 

not configured to be an FCF-facing interface.

The default behavior is configuration as a host-facing interface.

Interface (physical interface and port channel) Configuration

FCF

Fibre Channel Fabric

2CSPC4.X8100-SWUM102.book  Page 906  Friday, March 15, 2013  8:56 AM