Fujitsu N800 ユーザーズマニュアル
48
U41243-J-Z156-1-76
BIOS Setup
Configuration software and utilities
5.3.1
Starting BIOS Setup
You can call and use
BIOS Setup
under different circumstances:
–
When you turn on the system, after the POST memory test has been
completed
completed
–
When you reboot the system by pressing
[Ctrl]
+
[Alt]
+
[Del]
in DOS mode
–
When you have moved the CMOS clear switch to the ON position (enabled)
(see the section “Configuring the server and components” on page 38)
(see the section “Configuring the server and components” on page 38)
In the three above-mentioned cases, you will see the following prompt after the
system has booted:
system has booted:
Press
[F2]
to enter SETUP
Ê
Press
[F2]
to enter
BIOS Setup
.
I
In a fourth case, i.e. if CMOS/NVRAM has been corrupted, you will see
other prompts but not the
other prompts but not the
[F2]
prompt:
Warning: CMOS checksum invalid
Warning: CMOS time and date not set
Warning: CMOS time and date not set
In this case, BIOS will load the default values into CMOS and attempt to
boot.
boot.
When you see the
[F2]
prompt once more, set anew the System Time
and the System Date with the Main Menu of the
BIOS-Setup
(see section