Patton electronic 2960 ユーザーズマニュアル
Cable installation
23
Model 2960/2996 RAS User Manual
2 • Hardware installation
Connecting the Ethernet ports
The RAS has a single 10/100 Ethernet interface for connection to your LAN (see
). The Ethernet port
will autosense the correct speed of the local LAN and automatically negotiate half- or full-duplex operation.
This section describes connecting the RAS to the Ethernet LAN via an Ethernet hub, switch, or workstation.
This section describes connecting the RAS to the Ethernet LAN via an Ethernet hub, switch, or workstation.
Figure 8. Model 2960/2996 network and configuration ports
Connecting the 10/100Base-T Ethernet port to an Ethernet switch or hub
The 10/100Base-T Ethernet port (see
The 10/100Base-T Ethernet port (see
on page 23) is designed to connect to an Ethernet switch or hub.
Connect a straight-through CAT-5 cable (one wired as shown in
) between the RAS and the hub/
switch.
Figure 9. Straight-through RJ-45-to-RJ-45 Ethernet cable diagram
10/100
ETHERNET
RS-232
CONFIG
T1/E1/PRI WAN PORTS
1
2
3
4
EXPANSION MODULE