Patton electronic 2960 ユーザーズマニュアル
Cable installation
24
Model 2960/2996 RAS User Manual
2 • Hardware installation
Connecting the 10/100Base-T Ethernet port to an Ethernet-capable workstation
The 10/100Base-T Ethernet port can connect to a single Ethernet-capable workstation by means of a cross-
over cable. Refer to
The 10/100Base-T Ethernet port can connect to a single Ethernet-capable workstation by means of a cross-
over cable. Refer to
to assemble a cross-connect cable that will connect between the NIC Ethernet
port in the workstation and the RAS 10/100Base-T Ethernet port.
Figure 10. Cross-over RJ-45-to-RJ-45 Ethernet cable diagram
Connecting the EIA-561 RS-232 configuration port
Install the supplied DB-9-to-RJ-45 cable between the RAS RS-232 port (see
on page 23) and an open
serial port on your computer. If you need to assemble your own cable, refer to the pinout diagram in
Figure 11.
DB-9-to-RJ-45 cable
diagram
Connecting to the T1/E1/PRI WAN ports
An active T1/E1/PRI is not necessary to configure the RAS. However, an active T1/E1/PRI connection is required
to receive or make calls. The factory-set default configuration of the access server has the T1/E1 ports disabled.
to receive or make calls. The factory-set default configuration of the access server has the T1/E1 ports disabled.
Note
The cable connecting the T1/E1/PRI WAN ports to the RJ-48C ter-
mination jack should be CAT-3 or higher and extend no farther than
1 mile (1.6 km) from the digital services termination.
mination jack should be CAT-3 or higher and extend no farther than
1 mile (1.6 km) from the digital services termination.
10Base-T Workstation
RJ-45 Pin No.
RAS 10/100Base-T Port
RJ-45 Pin No.
(TX+)
(TX-)
(TX-)
(RX+)
(RX-)
(RX-)
1
2
2
3
6
6
(RX+)
(RX-)
(RX-)
(RX+)
(TX-)
(TX-)
3
6
6
1
2
2