Chicago Electric 42933 ユーザーズマニュアル

ページ / 24
SKU 42933 
For technical questions, please call 1-800-444-3353. 
Page 17
Bevel cross cutting
1.  Loosen the Bevel Lock Knob (71) and 
pull out the Bevel Index Knob (74).
Turn the motor assembly clockwise 
2. 
or counterclockwise, selecting the 
desired angle (variable or indexed, 
i.e., 45°). 
Tighten the Bevel Lock Knob (71) and 
3. 
push in the Bevel Index Knob (74).
Push the Handle backward so that 
4. 
the Saw Blade is in behind the stock 
to be cut.
Secure the stock to be cut against the 
5. 
table and fence. If the stock length 
is short, do not hold with your hand. 
Use a clamp to hold in place.
Adjust the Anti-kickback Arm (15) so 
6. 
it just clears the stock.
Press the green Switch (122). 
7. 
Squeeze the Trigger and push the 
Handle all the way back.
When the cut is complete, release the 
8. 
Trigger, push the Handle all the way 
back, and wait until the saw blade 
stops completely.
compound cross cutting
Compound crosscutting combines the mi-
tre and bevel functions. Set the Saw Blade 
angles as previously described. Continue 
to follow steps 4 through 9, above.
In-Rip cutting
Ripping is the process of cutting stock 
along the grain (or lengthwise). The stock 
if fed into the Saw Blade against the blade 
rotation (similar to a table saw). The fence 
is used as a guide to help maintain cutting 
width.
Loosen the yoke Clamp Handle (66) 
1. 
and pull out the Yoke Index Knob.
Turn the motor assembly to the left 
2. 
and lock the Yoke Index Knob at 90°.
Tighten the yoke Clamp Handle (66).
3. 
Adjust the Saw Blade Safety Guard 
4. 
(7) so it is just above the surface of 
the stock to be ripped.
Adjust the Anti-kickback Arm (13) so 
5. 
it is just above the stock surface.
Adjust the Carriage Arm so that the 
6. 
Saw Blade is at the desired depth for 
the rip cut, and securely lock the Car-
riage Lock Knob in place. 
Note that the larger portion of the 
stock being ripped should be be-
tween the Fence and the Saw Blade.
Adjust the Elevating Handle (100) so 
7. 
that the Saw Blade is 1/16” into the 
worktable.
Verify that the Bevel Index Knob is 
8. 
locked into 0°.