Chicago Electric 42933 ユーザーズマニュアル

SKU 42933 

Page 15

In order to move the Saw Blade into 

different cutting positions, kerf marks (or 

grooves) must be cut into the worktable. 

It is recommended to cut grooves into a 

piece of 1/4” plywood mounted to the sur-

face of Table A.

Cut a piece of 1/4” plywood the same 

1. 

size as Table A.
Mount the plywood to Table A using 

2. 

self-tapping, countersinking screws at 

the four corners of Table A.
Set the Carriage Arm at 0° and lock in 

3. 

place.
Set the Saw Blade angle to 0° index 

4. 

position (perpendicular to the work-

table).
Draw out the Saw Blade to mid-range 

5. 

on the Carriage Arm and lock in that 

position.
Turn the Elevating Handle to lower 

6. 

the Saw Blade so it just touches the 

plywood top.
Place your hand on the Handle As-

7. 

sembly (87) and press the green ON 

button with the other hand. Squeeze 

the Trigger (86) to start the motor.
With the same hand that you turned 

8. 

ON the machine, loosen the Carriage 

Lock Knob and slowly move the Saw 

Blade back, cutting the rip fence; and 

then move it all the way forward, cut-

ting a groove into the entire depth of 

the plywood.
With the machine still running, turn 

9. 

the Elevating Handle 1/4 turn, lower-

ing the Saw Blade a little more. Pull 

the Handle back and forth again to 

cut the plywood groove a little deep-

er. Tighten the Carriage Lock Knob 

again.

With the machine still running, loosen 

10. 

the yoke Clamp Handle (66) and pull 

out the Yoke Index Knob and turn the 

yoke clockwise until it locks into the 

90°. 

This cuts a swing line into the work-

table for in-ripping.
Once the quarter turn (swing line cut) 

11. 

is complete, lock the yoke Clamp 

Handle. With the Saw Blade still turn-

ing, push on the Handle until the Saw 

Blade reaches the rip fence, cutting 

the rip trough in the center of the 

worktable. 
Turn the machine OFF and return the 

12. 

Saw Blade to the crosscut position. 

Lock the Carriage Lock Knob.
Turn the machine ON and rotate the 

13. 

Yoke counterclockwise to the out-rip 

position. This cuts the swing line for 

out-ripping. Loosen the Carriage Lock 

Knob.
Lock the yoke Clamp Handle (66) 

14. 

and, with the Saw Blade revolving, 

push the Handle back until the new 

groove matches the groove cut in 

step 11. Turn the machine OFF.
Return the Saw Blade to the crosscut 

15. 

position. Unlock the Carriage Lock 

Knob (74b) and move the motor as-

sembly to the rear position, behind 

the fence. Pull out the Bevel Index 

Knob (74) and lock the Saw Blade at 

index position 60°. Turn on machine 

and pull the Handle forward. This will 

cut a kerf mark for bevel crosscuts. 

Turn the machine OFF.
Lock the Carriage Lock Knob and 

16. 

start the motor. Pull the Carriage Arm 

Index Lock Knob and move the Arm 

to the 45° right-hand miter position. 

This will cut a groove for miter cuts. 

Turn the machine OFF.