Husqvarna 326ES ユーザーズマニュアル
ASSEMBLY
English
–
13
1151020-95 Rev. 2 2008-03-10
Assembling the cutting
equipment
equipment
Assembling the blade (326Ex)
Fit the blade as follows:
1
Fit the drive disc (A) on the outgoing shaft. Make sure
that the edge that fits in the hole of the blade is facing
outward.
that the edge that fits in the hole of the blade is facing
outward.
2
Block the blade rotation by inserting the locking pin in
the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
3
Fit the blade (B) on the drive disc.
4
Fit the support flange (C). The support flange must be
fitted with its outer edge hard up against the blade.
fitted with its outer edge hard up against the blade.
5
Fit the locking nut (D). CAUTION! The locking nut has
a left-hand thread. Tighten the locking nut to a torque
of 35-50 Nm (3,5-5 kpm).
a left-hand thread. Tighten the locking nut to a torque
of 35-50 Nm (3,5-5 kpm).
6
Remove the locking pin.
CAUTION! Do not forget to remove the locking pin before
using the machine.
using the machine.
Assembling the blade (326ES)
Fit the blade as follows:
1
Fit the drive disc (A) on the outgoing shaft. Make sure
that the edge that fits in the hole of the blade is facing
outward.
that the edge that fits in the hole of the blade is facing
outward.
2
Block the blade rotation by inserting the locking pin in
the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
3
Fit the blade (B) on the drive disc.
4
Fit the support flange (C). The support flange must be
fitted with its outer edge hard up against the blade.
fitted with its outer edge hard up against the blade.
5
Fit the two washers (D) and the locking screw (E).
6
Tighten the locking screw to a torque of 18-25 Nm
(1,8-2,5 kpm).
(1,8-2,5 kpm).
7
Remove the locking pin.
CAUTION! Do not forget to remove the locking pin before
using the machine.
using the machine.
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
!
WARNING! Under no circumstances may
the edge cutter blade be used without the
blade guard fitted.
the edge cutter blade be used without the
blade guard fitted.
A
B
C
D
E