Alcatel-Lucent 6850-48 参照ガイド
QoS Policy Commands
page 53-118
OmniSwitch CLI Reference Guide
September 2009
policy condition source port group
Associates a source port group with a policy condition. Use the no form of the command to remove a
source port group from a condition.
source port group from a condition.
policy condition condition_name source port group group_name
policy condition condition_name no source port group
Syntax Definitions
condition_name
The name of the condition. May be an existing condition name or a new
condition.
condition.
group_name
The name of the source port group. Port groups are configured through
the policy port group command. See
the policy port group command. See
for more information
about this command.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
Use the no form of the command to remove a source port group from a condition; however, at least one
classification parameter must be associated with a condition.
classification parameter must be associated with a condition.
Examples
-> policy condition cond6 source port group portgr4
Release History
Release 6.1; command was introduced.
Related Commands
Configures a port group and its associated slot and port numbers.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.