Alcatel-Lucent 6850-48 参照ガイド

CMM Commands

page 1-8

OmniSwitch CLI Reference Guide

Copies the running configuration (RAM) to the working directory.

N/A

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• This command is used to copy the changes made using the CLI commands from the running 

configuration (RAM) to the working directory.

• This command is only valid if the switch is running from the working directory. Use the 

 command to check from where the switch is running.

Note. On an OmniSwitch set up with redundant CMMs, the saved boot.cfg file will be overwritten if the 

 command is executed after the write memory command.

-> configure write memory

-> write memory

Release 6.1; command was introduced. 

configManager

configWriteMemory

Copies the startup primary flash version of the CMM software to the 
startup secondary flash version of the CMM software.