Netgear HR314 参照マニュアル

ページ / 123
Reference Manual for the Model HR314 802.11a Hi-Speed Wireless Router
Basic Configuration of the Router
4-9
 
5.
Domain Name Server (DNS) Address: If you know that your ISP does not automatically 
transmit DNS addresses to the router during login, select “Use these DNS servers” and enter 
the IP address of your ISP’s Primary DNS Server. If a Secondary DNS Server address is 
available, enter it also.
A DNS server is a host on the Internet that translates Internet names (such as www 
addresses) to numeric IP addresses. Typically your ISP transfers the IP addresses of one or 
two DNS servers to your router during login. If the ISP does not transfer an address, you 
must obtain it from the ISP and enter it manually here. If you enter an address here, you 
should reboot your PCs after configuring the router.
6.
Router’s MAC Address: This section determines the Ethernet MAC address that will be used 
by the router on the Internet port. Some ISPs will register the Ethernet MAC address of the 
network interface card in your PC when your account is first opened. They will then only 
accept traffic from the MAC address of that PC. This feature allows your router to masquerade 
as that PC by “cloning” its MAC address. You can specify the MAC address in one of two 
ways:
a.
Select "Use this Computer’s MAC address". The router will then capture and use the 
MAC address of the PC that you are now using. You must be using the one PC that is 
allowed by the ISP.
b.
Select "Use this MAC address" and manually enter the MAC address you wish to use.
7.
Click on Apply, then proceed to 
.
Completing the Configuration
Click on the Test button to test your Internet connection. If the NETGEAR website does not 
appear within one minute, refer to 
”.
Your router is now configured to provide Internet access for your network. When your router and 
PCs are configured correctly, your router automatically accesses the Internet when one of your 
LAN devices requires access. It is not necessary to run a dialer or login application such as 
Dial-Up Networking or Enternet to connect, log in, or disconnect. These functions are performed 
by the router as needed.
To access the Internet from any PC connected to your router, launch a browser such as Microsoft 
Internet Explorer or Netscape Navigator. You should see the router’s Internet LED blink, 
indicating communication to the ISP. The browser should begin to display a Web page.
The following chapters describe how to configure the Advanced features of your router, and how 
to troubleshoot problems that may occur.