Netgear HR314 参照マニュアル

Advanced Configuration of the Router

8-9

— When set to Both or In Only, it will incorporate the RIP information that it receives. 

— When set to None, it will not send any RIP packets and will ignore any RIP packets 

received. 

•

RIP Version
This controls the format and the broadcasting method of the RIP packets that the router sends. 
(It recognizes both formats when receiving.) By default, this is set for RIP-1. 

— RIP-1 is universally supported. RIP-1 is probably adequate for most networks, unless you 

have an unusual network setup. 

— RIP-2 carries more information. RIP-2B uses subnet broadcasting..

Static Routes provide additional routing information to your router. Under normal circumstances, 
the router has adequate routing information after it has been configured for Internet access, and 
you do not need to configure additional static routes. You must configure static routes only for 
unusual cases such as multiple routers or multiple IP subnets located on your network.

From the Main Menu of the browser interface, under Advanced, click on Static Routes to view the 
Static Routes menu, shown in 

. 

To add or edit a Static Route:

If you change the LAN IP address of the router while connected through the 

browser, you will be disconnected. You must then open a new connection to the new IP 
address and log in again.