Sharp MX-2300N ユーザーガイド
45
This chapter explains the basic procedures for receiving a fax.
RECEIVING FAXES
When "Auto Reception" is enabled, the machine will receive faxes automatically.
The fax reception mode is displayed in the base screen.
The fax reception mode is displayed in the base screen.
4
FAX RECEPTION
• When fax reception is in progress, it is possible to reserve a transmission by performing the transmission in memory
transmission mode.
☞
(page 13)
• To print received faxes, make sure that the required paper is loaded in the machine's paper trays. It is not necessary to
load 8-1/2" x 11" (A4) paper and 5-1/2" x 8-1/2" (B5) paper in both the vertical (
) and horizontal (
) orientations.
Differences in orientation are automatically adjusted when faxes are received.
When a fax smaller than 8-1/2" x 11" (A4) size is received, the size of the paper used for printing will vary depending on the
orientation (vertical or horizontal) in which the sender placed the original.
When a fax smaller than 8-1/2" x 11" (A4) size is received, the size of the paper used for printing will vary depending on the
orientation (vertical or horizontal) in which the sender placed the original.
• System Settings for Fax: Fax Receive Settings
This is used to change the fax reception mode. "Auto Reception" should normally be used.
Select "Manual Reception" when an extension phone is connected to the machine.
Select "Manual Reception" when an extension phone is connected to the machine.
☞
(page 160)
• System Settings for Fax (Administrator):
This setting is used to enter fax numbers from which you wish to block reception.
Quick File
File
Special Modes
Sub Address
Speaker
Resend
Address Book
Fax
Mode Switch
Direct TX
Memory TX
Auto Reception
Ready to send.
Image
Settings
Fax Memory:100%
This shows the current fax
reception mode and the amount
of free memory remaining.
reception mode and the amount
of free memory remaining.