Sharp MX-2300N ユーザーガイド

When a fax is transmitted to the machine, the machine automatically receives and prints the fax.

When reception ends, a beep sounds.

• System Settings for Fax (Administrator): 

This is used to change the volume and tone of the reception beep.

• System Settings for Fax (Administrator): 

This is used to change the number of rings on which fax reception begins automatically. To receive faxes without 
the machine ringing, select "0" rings except for some regions.

• If a password entry screen appears...

A password must be entered to print the received fax. When the correct password is entered, the received fax is 
printed.

☞

 (page 47)

• The output tray and stapling can be selected (when a finisher is installed).

The number of copies of received faxes that are printed and the output tray can be selected. When a finisher is 
installed, the number of copies printed, the output tray, and stapling can be selected.

☞

System Settings for Fax (Administrator): 

 (page 184)

• If printing of a copy job or print job is in progress when a fax is received, the fax will not be printed until the previously 

reserved job is completed.

• Received faxes will not be printed when the machine cannot print due to an error condition such as out of paper, out of 

toner, or a paper misfeed. The faxes will be printed automatically when the error condition is cleared (however, if the 
machine ran out of paper, touch the [OK] key in the touch panel after adding paper).

• When received faxes cannot be printed, the faxes can be forwarded to another fax machine.

☞

FORWARDING RECEIVED FAXES (Fax Data Forward)

 (page 101)

This is used to have received faxes printed on both sides of the paper.

Beep