Aethra d2061 ユーザーズマニュアル

ADSL TESTER D2061 

                                                                                        USER’S MANUAL 

 

► 

The LED LINK is OFF if the physical connection is not active, is ON (solid 
yellow) during the connection phase, is ON (solid green) when the connection 
is active, is ON (solid red) when an error occurs. 

In order to perform the ATM Ping test, define the following parameters: 

Cell type: Select the type of traffic to simulate: 

•  F5 end to end, OAM F5 cell type used for controlling the entire connection 

(end to end).  

•  F5 segment, OAM F5 cell type used for controlling a single segment of the 

connection. 

•  F4 end to end, OAM F4 cell type used for controlling the entire connection 

(terminal - exchange). 

•  F4 segment, OAM F4 cell type used for controlling a single segment of the 

connection (terminal - exchange). 

VPI: Virtual Path Identifier, default value is 8, on which flows the required traffic. 

VCI: Virtual Channel Identifier, default value is 35, on which flows the required traffic. 

Location ID: Enter the ID address, made by hexadecimal octets, necessary for 
identifying and controlling a single segment of the connection. Only F4/F5 segment. 

Ping request number: Insert the number of Ping (Echo) requests. 

Max response time (sec): Maximum response time between Ping requests. The 
test set waits this time before considering the request expired. 

 

 

 

38

 

CHAPTER 3 - PERFORMING A MANUAL TEST