Aethra d2061 ユーザーズマニュアル
ADSL TESTER D2061
USER’S MANUAL
The instrument supports four impedance models: 600
Ω resistive,
CTR21 standard, complex impedance (Belgium), complex
impedance (Germany, Spain).
impedance (Germany, Spain).
Line current limit (mA): Maximum current load that the instrument puts on the line
Selection mode: select the dialing mode for the telephone number between tone
(DTMF) and pulse (decade) 40/60 or 33/66.
(DTMF) and pulse (decade) 40/60 or 33/66.
Flash time(msec): Break time to simulate the Flash key.
DTMF Tx level (dbr): The level of the output DTMF tones.
3.4. Connection
In order to verify the access parameters you run this test to start the link and read the
values displayed. This test can be performed in conjunction with the others test.
values displayed. This test can be performed in conjunction with the others test.
The display shows the Test Status (running or not).
►
The LED STATUS is OFF if no test running, is ON (solid greeen) during
regular test running, is ON (red) when an error/alarm occurs.
regular test running, is ON (red) when an error/alarm occurs.
►
The LED LINK is OFF if the physical connection is not active, is ON (solid
yellow) during the connection phase, is ON (solid green) when the connection
is active, is ON (solid red) when an error occurs.
yellow) during the connection phase, is ON (solid green) when the connection
is active, is ON (solid red) when an error occurs.
The test results displayed are the following:
MODE
Line mode
FAST
ATM Fast mode bit rate
(Kbps)
INTER
ATM Interleaved mode bit rate
(Kbps)
MAX
ATM maximum line rate
(Kbps)
CAP.
Relative Capacity
(%)
MARGN
Noise Margin
(dB)
ATTEN
Attenuation
(dB)
POWER
Output Power
(dBm)
ATU-C ID
ATU-C manufacturer ID
Solo ANSI
VER
ATU-C compatibility version
Solo ANSI
Where:
36
CHAPTER 3 - PERFORMING A MANUAL TEST