Aethra d2061 ユーザーズマニュアル
USER’S MANUAL
ADSL TESTER D2061
Location ID: Enter the ID address, made by hexadecimal octets, necessary for
identifying and controlling a single segment of the connection. Only F4/F5 segment.
identifying and controlling a single segment of the connection. Only F4/F5 segment.
Average rate (cells/sec): Set the traffic’s average rate generated by the device
expressed in number of cells per second.
expressed in number of cells per second.
Burst (cells): Define the number consecutive cells that compose the packet AAL5.
The packet’s content is predefined and valid only for this test. Only for AAL5 test.
The packet’s content is predefined and valid only for this test. Only for AAL5 test.
3.6.2. Running an ATM Generate Traffic test
In order to obtain correct data, the remote device must be
enabled for managing the OAM maintenance cells or it may
perform a loop of AAL5 packet, or it must be another D2061.
enabled for managing the OAM maintenance cells or it may
perform a loop of AAL5 packet, or it must be another D2061.
Once defined the parameters to perform the IP Ping test, continue as follows:
1
Select ‘Use this setup for testing’.
2
Connect the instrument as displayed on the screen and
press the RIGHT CURSOR key.
press the RIGHT CURSOR key.
3
Start the test.
►
The LED STATUS is OFF if no test running, is ON (solid green)during regular
test running.
test running.
►
The LED LINK is OFF if the physical connection is not active, is ON (solid
yellow) during the connection phase, is ON (solid green) when the connection
is active, is ON (solid red) when an error occurs.
yellow) during the connection phase, is ON (solid green) when the connection
is active, is ON (solid red) when an error occurs.
The test results appear on the screen:
The status line indicates the status of the test.
CHAPTER 3 - PERFORMING A MANUAL TEST
41