Ricoh fax3310l ユーザーガイド

8.2 Status Report

8-2

8.1.2 Error Conditions

Combinations of blinking LEDs — 1 to 7 orange blinks followed by 1 to 12 green blinks 
— indicate various hardware failures. You should then notify the supplier of your printer 
according to whatever arrangements you have for technical support or replacement of 
defective equipment.

The Status/Configuration report is generated when the print server is powered on (if the 
Print Status Report on Power up feature is enabled). The following sample report shows 
the configuration of the print server immediately before the report is printed. Some 
printers also allow you to use a command from the front panel that produces a status 
report.

You should generate and review a status report after installation and any time the setup 
changes. If your status report does not include a protocol that was configured, make sure 
the procedure was done properly.

---------------------------------------------------------------------

Unit Serial No: 123456               Version: 05.60

Network Address:  00:11:22:33:44:55

Network Topology: Ethernet           Connector: RJ45

Network Speed: 100 Megabits

Novell Network Information           enabled

    Novell Print Server Name: RDP_123456

    Password Defined: No

    Directory Services Context not defined

    Frame Type: 802.3

Peer-to-Peer Information             enabled

    Frame Type: 802.2 on 802.

    Network ID: 6

TCP/IP Network Information           enabled

    Frame Type: Ethernet II          Protocol Address: 123.123.123.123

    Subnet Mask: 123.123.123.123     Default Gateway:  123.123.123.123

    WINS Name:

IPP Network Information              enabled

    Internet Printing Protocol       http://123.123.123.123:631/Print

AppleTalk Network Information        enabled