Ricoh AP400 ユーザーガイド
Remote Maintenance by telnet
115
7
Setting IEEE 802.11b
To make setting for IEEE 802.11b, use the wiconfig command.
Limitation
❒ You can make settings when installing the optional 802.11b Interface Unit.
❖
❖
❖
❖ View settings
The IEEE 802.11b settings are displayed.
msh> wiconfig
The IEEE 802.11b card information is displayed.
The IEEE 802.11b card information is displayed.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is not working correctly, the IEEE 802.11b card
information is not displayed.
❖
❖
❖
❖ Configuration
Parameter
Value to be configured
mode [ap|adhoc|802.11adhoc]
You can set infrastructure mode (ap), 802.11
ad hoc mode (802.11adhoc) or ad hoc mode
(adhoc).
The default is ad hoc mode.
ad hoc mode (802.11adhoc) or ad hoc mode
(adhoc).
The default is ad hoc mode.
ssid ID value
You can set for SSID in infrastructure mode.
The characters that can be used are ASCII
0x20-0x7e (32 bytes).
0x20-0x7e (32 bytes).
A SSID value is set automatically to the near-
est access point if the setting has not been
made.
est access point if the setting has not been
made.
If the setting has not been made for ad hoc
mode, the same value as for infrastructure
mode or an "ASSID" value is set automatical-
ly if the setting has not been made.
mode, the same value as for infrastructure
mode or an "ASSID" value is set automatical-
ly if the setting has not been made.
channel frequency channel no.
You can set the channel.
You can specify from following channel.
• Metric Version :1-13
• Metric Version :1-13
• Inch Version :1-11
Set the same channel for all the machines you
are using.
are using.
enc [on|off]
You can enable or disable the WEP function.
To enable the WEP function, specify [on]; to
disable it, specify [off].
To enable the WEP function, specify [on]; to
disable it, specify [off].
To start the WEP function, enter the correct
WEP key.
WEP key.