Ricoh AP400 ユーザーガイド
Remote Maintenance by telnet
117
7
• smb
msh> spoolsw smb {on |off}
Changing the Host Name
Use the hostname command to change the printer name.
msh> hostname [interface_name ] printer_name
*1
If you did not enter the interface name, it will be automatically set to the Ethernet in-
terface.
*2
If you install the 802.11b Interface Unit Type A, you can set the command.
*3
If you install the 1394 Interface Unit Type 4510, you can set the command.
Note
❒ Enter the printer name using up to 13 characters.
❒ You cannot use a printer name starting with RNP or rnp.
❒ The Ethernet interface and IEEE 802.11b interface will have the same printer
❒ You cannot use a printer name starting with RNP or rnp.
❒ The Ethernet interface and IEEE 802.11b interface will have the same printer
name.
WINS
Use the wins command to configure the WINS server settings
For more information about WINS server settings, see p.141 “Configuring a
WINS Server”.
For more information about WINS server settings, see p.141 “Configuring a
WINS Server”.
❖
❖
❖
❖ Viewing setting
The following command displays the WINS server IP address.
msh> wins
Example out put:
Example out put:
wins: primary server 0.0.0.0 secondary server 0.0.0.0
DHCP current config:
p r i m a r y s e r v e r 1 9 2 . 1 6 8 . 1 0 . 1 s e c o n d a r y s e r v e r
192.168.10.2
hostname RNP620B47 ScopeID
DHCP current config:
p r i m a r y s e r v e r 1 9 2 . 1 6 8 . 1 0 . 1 s e c o n d a r y s e r v e r
192.168.10.2
hostname RNP620B47 ScopeID
Note
❒ If DHCP is used to start from the network, the current WINS server ad-
dress is displayed. This address, however, is not displayed if DHCP is not
used.
used.
❒ If the IP address obtained from DHCP differs from the WINS IP address,
the DHCP address is the valid address.
interface name
Interface to be configured
ether
Ethernet interface
IEEE 802.11b interface
ip1394
IEEE 1394 interface