Ricoh AP400 ユーザーガイド
Appendix
116
7
Job Spool
Use this command to configure Job Spool settings.
Limitation
❒ You can only specify the LPR and IPP protocol.
❖
❖
❖
❖ Reference
The job spool setting appears.
msh> spoolsw
❖
❖
❖
❖ Job Spool Setting
msh> spoolsw spool {on | off}
Note
❒ Specify "on" to enable the job spool function or "off" to disable it.
❖
❖
❖
❖ Protocol Configuration
To change the protocol settings, use the following command. You can specify
the setting for [lpr] or [ipp].
• lpr
the setting for [lpr] or [ipp].
• lpr
msh> spoolsw lpr {on | off}
• ipp
msh> spoolsw ipp {on | off}
key [key value]
With 64-bit WEP, you can use 10 digit hexa-
decimal. With 128-bit WEP, you can use 26
digit hexadecimal.
decimal. With 128-bit WEP, you can use 26
digit hexadecimal.
To use this function, set the same WEP key
for all ports that transmit to each other.
for all ports that transmit to each other.
auth [open|shared]
You can set the authorized mode when using
WEP. The specified value and the authorized
mode are as follows:
WEP. The specified value and the authorized
mode are as follows:
open: Open system authorized (default)
shared: Shared key authorized
rate [auto|11m|5.5m|2m|1m]
You can set the IEEE 802.11b transmitting
speed.
speed.
The transmitting speed you specify here is
the speed at which data is sent. You can re-
ceive data at any speed.
the speed at which data is sent. You can re-
ceive data at any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
5.5m: 5.5 Mbps fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
Parameter
Value to be configured