Frigidaire frt22irshk5 ユーザーガイド

ページ / 18
8
Ice maker tips
1. Ice cubes stored too long may develop an odd flavor. Empty the container and
be sure the wire signal arm is in its “down” or ON position. The Ice Maker will
then produce more ice.
2. Occasionally shake the container to keep ice separated.
3. Keep the wire signal arm in its “up” or OFF position until the refrigerator is
connected to the water supply or whenever the water supply is turned off.
4. Certain sounds are normal when the Ice Maker is operating. They are:
• Motor operation
• Ice being loosened from the tray
• Ice dropping into the storage bin
• Running water
• Water valve opening or closing
For more information on these operations, see Normal Operating Sounds.
5. Wash ice container in warm water with mild detergent. Rinse well and dry.
6. Stop the Ice Maker when cleaning the freezer or for short vacations.
7. If the Ice Maker is to be turned off for a long period of time, turn the water
supply valve to the closed position.
Automatic Ice Maker
(continued)
Removing Handles and
Doors
If it is necessary to move the refrigerator through narrow doorways, follow
these steps to remove the handles and/or refrigerator and freezer doors.
       Use care when using tools near surface of stainless steel doors to avoid
scratching.
To Remove Handles
Remember to save the screws.
1. Keep a firm hold on handle while removing screws, so handle does not fall.  To
loosen or remove set screws, use a 3/32" allen wrench.
2. Remove handle.
3. To remove shoulder screws, use a 3/8" open end wrench.
4. Repeat these steps for each handle.
To Reinstall Handles
Reverse handle removal instructions.  NOTE:  Do not tighten shoulder screws too
tight.
To Remove Doors
Before removing doors, be sure freezer control is turned to OFF. Remove all food from
doors. Unplug refrigerator. Remove toe grill.
Trace around hinges with a soft lead pencil. This will make it easier to realign doors
when they are replaced. Completely remove one door before starting to remove the
other.
Removing handles
Shoulder screw
Shoulder
screw
Set screws
Set screws
To stop the ice maker, lift the wire signal arm until it clicks and locks in the “up” or
OFF position. The ice maker turns off automatically when the ice container is full. If your
model has an adjustable freezer shelf, place the shelf so the wire signal arm will hit the
ice when the ice container is full.