Lowrance lmf-400 ユーザーズマニュアル

38

1. From the Fuel Setup menu, select 

 and press Enter,

which will launch the following message: Press Enter to Reset Trip
Fuel.
2. Press 

, which will take you back to the Fuel Setup menu. Press

 repeatedly to return to the main display.

System Setup Menu

To get to the System Setup menu, press 

, then scroll down to

System Setup and press 

. The System Setup

menu contains

Engine Displayed, Bus Devices, Sonar Alarms, Eng/Tank
Configuration, Reset Values, System Information and Change Units.

Engine Displayed
The Engine Displayed command allows you to monitor up to three
engines on your vessel.

  

Basic menu with System Setup highlighted (left). System Setup menu

(right) with Engine Displayed selected.

1. After accessing the System Setup menu, highlight 

and press 

. A menu will appear with the following options: Port,

Center and Starboard. This is important when viewing information like
Fuel Management, RPM and Engine Voltage.
2. Select the engine you would like to monitor and press 

.

Bus Devices
1. To run a system check for devices connected to the NMEA 2000
network, choose 

from the System Setup menu and press

After a Searching for Bus Devices message comes up, a list of

all devices attached to the LowranceNET — the Bus Devices list — will
appear.
Sonar Alarms
1. If you would like to set Deep or Shallow Sonar Alarms, select 

from the System Setup menu and press 

. An alarm menu

will pop up with two choices: Shallow or Deep.