TallyGenicom 3860 クイック設定ガイド

3860/80 Quick Reference Guide

29

•

 

When using a table or desk for the printer, position the printer and
paper supply so that the paper does not drag on the edge of the
surface as it enters the printer. The printer should be as close to the
edge of the table or desk as possible.

•

 

Place the paper box so that paper flows out of it without dragging on
the sides of the box.

•

 

Each time a new box of paper is started, bend the flaps down and
tape them to the sides of the box or cut them off.  Also pull the sides
of the box away from the paper stack to allow clearance.

•

 

If printing bar codes, using stiff forms, or using thick multipart forms,
place the paper supply beneath the printer and use the bottom paper
path.

•

 

As the paper supply begins to run low, remove the remaining paper
stack from the box and place it beneath the printer.

•

 

When printing graphics or bar codes, do not use  tear-off to view the
page. Paper moves backwards during a tear-off cycle, and
sometimes this causes a tiny error in vertical registration.  The error
is not noticeable when printing text, but an error as small as 1/72
inch shows up as a horizontal stripe in graphics or bar codes.