TallyGenicom 3860 クイック設定ガイド
GEK-01054
30
Connecting the Printer to a Host System
Attach to a Data Source
Specific instructions for connection to an SCS or IPDS data source can
be found in the
be found in the
3972 SCS Guide and 3974 IPDS Guides.
The printer is shipped with auto switching of interfaces enabled. Serial
and parallel interfaces are standard, see Chapter 2 of the
and parallel interfaces are standard, see Chapter 2 of the
3860/80 User’s
Manual.
CENTRONICS/IBM parallel and RS-232 serial printer cables are
available from any computer store. The cables must be rated FCC Class
B in order for the system to meet legal radio frequency interference
limits. The cables should have a braided shield to provide best immunity
from electrostatic discharge.
available from any computer store. The cables must be rated FCC Class
B in order for the system to meet legal radio frequency interference
limits. The cables should have a braided shield to provide best immunity
from electrostatic discharge.
WARNING:
When connecting interface cables, turn the printer and data source
off to avoid potential damage.
off to avoid potential damage.
Connect the cable.
Install the cable and tighten cable connector screws or, when using the
parallel interface, secure the cable to the printer with the bail wires on the
printer connector.
parallel interface, secure the cable to the printer with the bail wires on the
printer connector.
Turn the data source and printer on.
To be safe, do it in that order.
Serial Interface Connector
Parallel Interface Connector