D-Link DAS-3224 ユーザーズマニュアル
D-Link DAS-3248 IP DSLAM
94
atmVCCAAL5EncapType is llc. In Mgmt mode, EoA
interface cannot be created on the ATM VC and
both Ethernet as well as non-ethernet packets on
that ATM VC shall be received at the Control Plane.
In DataAndMgmt mode, if EoA is created, then only
non-ethernet packets on that ATM VC shall be re-
ceived at the Control Plane. However, if EoA is not
created then all the packets on that ATM VC shall
be received at the Control Plane. However, to
configure ATM VC in DataAndMgmt mode, a good
practice is to to create ATM VC in disable mode till
EoA is created on it, to prevent flooding at Control
Plane. In order to run STP, the mode has to be
DataAndMgmt. If the mode is RawATM(4), ATM
cells are given to Control Plane. In this mode, EoA
interface can ot be created on the ATM VC. If EoA
interface is already created on the ATM VC, its
mode cannot be changed to either Mgmt(2) or
RawATM(4).
interface cannot be created on the ATM VC and
both Ethernet as well as non-ethernet packets on
that ATM VC shall be received at the Control Plane.
In DataAndMgmt mode, if EoA is created, then only
non-ethernet packets on that ATM VC shall be re-
ceived at the Control Plane. However, if EoA is not
created then all the packets on that ATM VC shall
be received at the Control Plane. However, to
configure ATM VC in DataAndMgmt mode, a good
practice is to to create ATM VC in disable mode till
EoA is created on it, to prevent flooding at Control
Plane. In order to run STP, the mode has to be
DataAndMgmt. If the mode is RawATM(4), ATM
cells are given to Control Plane. In this mode, EoA
interface can ot be created on the ATM VC. If EoA
interface is already created on the ATM VC, its
mode cannot be changed to either Mgmt(2) or
RawATM(4).
RowStatus
This defines the row-status of the interface entry
VC Type
This field specifies whether VC type is PVC or SVC.
VC Topology
This field specifies the VC connection topology
type.
type.
Caution The specified lower interface should exist. Please refer to the
create atm port command.
References • ATM interface commands
.
• ATM statistics commands
.
• ATM OAM commands
.
• ATM VC statistics commands.
5.5.4 AAL5 VC Statistics Commands
get atm aal5 stats
Description: Use this command to get AAL5 VC statistics.
Command Syntax: get atm aal5 stats [ifname interface-name]
Parameters
Name
Description
ifname
interface-name
interface-name
This parameter specifies the interface for which information
is desired
Type: Get -Optional
Valid values : aal5-0 - *
is desired
Type: Get -Optional
Valid values : aal5-0 - *
Example $ get atm aal5 stats ifname aal5-0
Output
Output
Low IfName : atm-0 VC IfName : aal5-0
VPI : 0 VCI : 1
Tx Frames count : 100 Rx Frames count : 85
Tx Bytes count : 1535 Rx Bytes count : 1200
CRC Errors count : 0 Oversized SDU : 0
CRC Errors count : 0 Oversized SDU : 0
Output Fields
FIELD
Description
VC IfName
The name of the aal5 (aal5-0 etc) interface, for