Netgear WC7520 - ProSafe 20-AP Wireless Controller 参照マニュアル

Click Next to continue. The following occurs:

The wireless controller searches for NETGEAR products on the LAN based on MAC 

address, and then identifies which products are supported access point models.

When discovery is finished, the table shows the access points that were located: for 

each access point, the table includes the model number, IP address, MAC address, 
and name.

The next Discovery Wizard Select Access Points to Manage screen displays. The following 
figure shows the screen after the access points have been discovered:

Check the discovery results to make sure that all the access points are listed. See the 
following section, 

.

Select the site designation and add the access points as described in 

Discovery Results

The effectiveness of autodiscovery depends in part on how the access points on your LAN 
are set up. If each access point is configured with a unique IP address and is running current 
firmware, then discovery is usually simple. 

If the discovery results are not what you expect, check the following:

Access points already managed by the wireless controller are not in the discovery list. To 

view the Managed AP List, select Access Point > Managed AP List.

The access points might be in a different IP subnet. Verify that you can ping the access 

point’s IP address from the wireless controller’s ping utility (see 

If the access points are in factory default mode and across a router, they are not detected.

With the exception of access points in factory default state that are in the same layer 

network, if more than one access point has the same IP address, then only one of them is