Netgear WC7520 - ProSafe 20-AP Wireless Controller 参照マニュアル
Access Point Discovery and Management
57
ProSafe 20-AP Wireless Controller WC7520
discovered at a time. You have to add the access point to the managed list, change its IP
address, and then run discovery again to discover the next access point with that IP
address.
address, and then run discovery again to discover the next access point with that IP
address.
•
Make sure that a DHCP server is available in the network or on the wireless controller.
Note:
Manage the Access Point List
Add Access Points to the Managed List after Discovery
After the wireless controller autodiscovers the access points, as explained in
on page 51, select the site designation and then add the
access points to the managed list so that the wireless controller can manage them.
To select the site designation and add discovered access points to the managed list:
1.
On the last Discovery Wizard screen (Step 3 of X: Select Access Points to manage; see
on page 56) that displays the discovered access points, select an access
point that you want to designate as a remote access point.
2.
From the Site drop-down list, select Remote. The default is Local. (All access points for
which you do not change the site designation to Remote are designated as Local.)
which you do not change the site designation to Remote are designated as Local.)
3.
Repeat
for each access point that you want to designate as a remote
access point.
4.
Select the check boxes for individual access points, or select the check box on the upper left
to select all access points.
to select all access points.
5.
Click Add. Depending on the type of access points that have been discovered, a screen that
lets you enter or ignore a login name and password might display.
lets you enter or ignore a login name and password might display.
The access points are added to the Managed AP List, and the wireless controller
upgrades the firmware of the access points to the latest firmware that is loaded on the
wireless controller.
upgrades the firmware of the access points to the latest firmware that is loaded on the
wireless controller.
•
If you want to wait until later to add the discovered access points, you can select
Access Point > Last Discovered to view the most recently discovered access
points. From this screen, you can add the access points to the Managed AP List.
points. From this screen, you can add the access points to the Managed AP List.
•
After you have added the access points to the Managed AP List, they are removed
from the discovery results and the Last Discovered screen.
6.
Select Access Point > Managed AP List. The Managed AP List screen displays. Because
this is a wide screen, it is shown in the following two figures:
this is a wide screen, it is shown in the following two figures: