Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル
Chapter 18. STP
|
575
NETGEAR 8800 User Manual
STP Configuration Examples
This section provides four configuration examples:
Basic 802.1D Configuration Example
The following example:
•
Removes ports from the VLAN Default that will be added to VLAN Engineering.
•
Creates the VLAN Engineering.
•
Assigns a VLAN ID to the VLAN Engineering.
Note:
If you do not explicitly configure the VLAN ID in your 802.1D
deployment, use the
show vlan
command to see the internal VLAN ID
automatically assigned by the switch.
•
Adds ports to the VLAN Engineering.
•
Creates an STPD named Backbone_st.
•
Configures the default encapsulation mode of dot1d for all ports added to STPD
Backbone_st.
•
Enables autobind to automatically add or remove ports from the STPD.
•
Assigns the Engineering VLAN to the STPD.
•
Assigns the carrier VLAN.
Note:
To assign the carrier VLAN, the StpdID must be identical to the VLAN
ID of the carrier VLAN.
•
Enables STP.
configure vlan default delete ports 2:5-2:10
create vlan engineering
configure vlan engineering tag 150
configure vlan engineering add ports 2:5-2:10 untagged
create stpd backbone_st
configure stpd backbone_st default-encapsulation dot1d
enable stpd backbone_st auto-bind vlan engineering
configure stpd backbone_st tag 150
enable stpd backbone_st