Netgear FVS318N – Prosafe Wireless N VPN Firewall プリント

IPv6 Tunnel Commands

This command configures a new ISATAP tunnel. After you have issued the net 
ipv6_tunnel isatap add

 command, you enter the net-config [isatap-tunnel] mode, and 

then you can configure one keyword and associated parameter or associated keyword at a 
time in the order that you prefer.

To configure an ISATAP tunnel, you first need to set the IP mode to 

IPv4/IPv6 (see 

net

net-config [isatap-tunnel]

The IPv6 64-bit subnet prefix (string) that is assigned to 
the logical ISATAP subnet for this intranet.

 or Other_IP

Specifies the local endpoint IP address for the tunnel that 
is initiated on the wireless VPN firewall. The endpoint can 
be the LAN interface or a specific LAN IPv4 address. If you 
select Other_IP, you also need to issue the 
ipv4_address

 keyword to specify an IPv4 address.

The IPv4 address of a local endpoint that is not a LAN IPv4 
address.

FVS318N> net ipv6_tunnel isatap add 

net-config[isatap-tunnel]> subnet_prefix 2004:: 

net-config[isatap-tunnel]> end_point_type Other_IP 

net-config[isatap-tunnel]> ipv4_address 10.29.33.4 

net-config[isatap-tunnel]> save

net ipv6_tunnel isatap add 

subnet_prefix <subnet prefix>

end_point_type {LAN | Other_IP {ipv4_address <address>}}