Netgear WNDA3100v2 – N600 Wireless Dual Band USB Adapter ユーザーズマニュアル

4-1

This chapter provides information about troubleshooting your wireless-N USB adapter. For 
information about connecting to wireless networks and the Internet, see 

Use the following information to solve common problems you may encounter. Also, refer to the 
knowledge base on the NETGEAR website at 

The LED is not lit.

The wireless-N USB adapter is not connected to the USB port 
correctly or the WNDA3100v2 software is not loaded. 
• Remove and reinsert the WNDA3100v2.
• Check the Windows device manager to see if the wireless-N 

USB adapter is recognized and enabled. Reload the 
WNDA3100v2 software, if necessary.

• Try to install the wireless-N USB adapter in a different USB 

slot on your system if one is available.

The LED blinks, but the wireless-N USB 
adapter is not connected to a router or 
access point.

The wireless-N USB adapter is trying to connect, but is 
unsuccessful. 
• The router might not be powered on. 
• The router and the wireless-N USB adapter are not 

configured with the same wireless parameters. Check the 
SSID and wireless security settings.

Push ‘N Connect WPS time out error during 
installation. 

This can occur if there are WPS routers in the area but your 
router does not support WPS. Make sure that you selected the 
correct wireless network. To select a network to join, see 

. For a WPS-capable router,