Bosch TES 50129 RW ユーザーズマニュアル

Robert Bosch Hausgeräte GmbH

Important: If a water filter is used (special 

accessory order no. 461732), proceed as 

follows, see „Water filter“ on page 10.

Note: If no button is pressed within 90 sec-

onds, the appliance switches to stand-by 

mode without saving the new settings. In 

this case, the previously saved water hard-

ness setting is retained.

Here you can set the period of time after 

which the appliance should switch off au-

tomatically following the last drink prepa-

ration. A time between 15 minutes and 4 

hours can be set. The default time is 1 hour, 

but this can be shortened to save energy.

1.  Turn the rotary  

knob (13) to position 

 

2.  Press and hold buttons 

B

 (11) and 

A

 

(12) simultaneously for at least 5 sec-

onds. The time after which the appliance 

should switch off is indicated by the 

number of LEDs that now light up.

3.  Now press the start button (10) repeat-

edly until the required number of LEDs 

light up to indicate the switch-off time:

D

 = 15 minutes

D

 and 

E

 = 30 minutes

D

, 

E

 and 

F

 = 45 minutes

D

, 

E

, 

F

 and 

G

 = 1 hour

D

, 

E

, 

F

, 

G

 and 

H

 = 2 hours

D

, 

E

, 

F

, 

G

, 

H

 and 

I

 = 4 hours

4.  Press and hold the start button (10) for 

at least 5 seconds. The set number of 

LEDs will light up to indicate that the 

selected switch-off time has been saved 

successfully.

Note: If no button is pressed within 90 sec-

onds, the appliance switches to stand-by 

mode without saving the new settings. In 

this case, the previously saved switch-off 

time is retained.

The brewing temperature can also be set.

1.  Turn the rotary  

knob (13) to position 

 

2.  Press and hold buttons 

B

 (11) and 

A

 (12) for at least 5 seconds. The set 

brewing temperature is indicated by the 

number of LEDs that now light up.

3.  Now press the start button (10) repeat-

edly until the required number of LEDs 

light up to indicate the temperature:

LED 

D

 = low

LED 

D

 and 

E

 = medium

LED 

D

, 

E

,and 

F

 = high

4.  Press and hold the start button (10) for 

at least 5 seconds. The set number of 

LEDs will light up to indicate that the 

selected temperature has been saved 

successfully.

Note: If no button is pressed within 90 

seconds, the appliance switches to stand-

by mode without saving the new settings. 

In this case, the previously saved brewing 

temperature setting is retained.

The selector (3) for grind setting adjusts the 

grind settings from coarse to fine.

Adjust the grinding unit only while it is run-

ning! Otherwise the appliance may be dam-

aged. Do not reach into the grinding unit.

TES501_Heft1_RW.indb   12

14.09.2011   16:10:24