Cisco Cisco Unified IP Interactive Voice Response (IVR) 8.0(1) インストールガイド
Chapter 3 Installation and Upgrade Requirements, Prerequisites, and Related Procedures
Installation and Upgrade Notes
3-30
Cisco Customer Response Solutions Installation Guide, Release 6.0(1)
•
The BARS must be configured so that only one server in the Cisco CRS
cluster is the data source server. In this way, a scheduled backup will not back
up the cluster multiple times. However, even though only one server in the
Cisco CRS cluster is configured as the data source server, all nodes in the
cluster must be configured as backup targets.
cluster is the data source server. In this way, a scheduled backup will not back
up the cluster multiple times. However, even though only one server in the
Cisco CRS cluster is configured as the data source server, all nodes in the
cluster must be configured as backup targets.
For detailed information about installing, configuring, and operating the
BARS, refer to the latest version of Cisco IP Telephony Backup and Restore
System (BARS) Administration Guide, which is available at this URL:
BARS, refer to the latest version of Cisco IP Telephony Backup and Restore
System (BARS) Administration Guide, which is available at this URL:
•
After you complete an upgrade or a restore procedure from a Cisco CRS
4.0(x) deployment that includes high availability, follow these steps to
confirm that the procedure is successful:
4.0(x) deployment that includes high availability, follow these steps to
confirm that the procedure is successful:
a.
Start and log in to the Cisco CRS Administration application, choose
System > Datastore Control Center, and click the Historical link.
System > Datastore Control Center, and click the Historical link.
b.
For the server for which the Replication Type is Publication Snapshot
Agent, make sure that the Replication Status is in STOPPED state and
that the LastAction shows “A snapshot of n article(s) was generated.” If
the LastAction shows something else while the Replication Status is in
STOPPED state, click the radio button for the Publication Snapshot
Agent and then click Restart.
Agent, make sure that the Replication Status is in STOPPED state and
that the LastAction shows “A snapshot of n article(s) was generated.” If
the LastAction shows something else while the Replication Status is in
STOPPED state, click the radio button for the Publication Snapshot
Agent and then click Restart.
c.
For server for which the Replication Type is Subscription Agent, make
sure that the Replication Status is in RUNNING state and that the
LastAction shows “No data needed to be merged.” If the Replication
Status is in STOPPED state, click the radio button for the Publication
Snapshot Agent and then click Restart, then click the radio button for the
Subscription Agent and then click Restart.
sure that the Replication Status is in RUNNING state and that the
LastAction shows “No data needed to be merged.” If the Replication
Status is in STOPPED state, click the radio button for the Publication
Snapshot Agent and then click Restart, then click the radio button for the
Subscription Agent and then click Restart.
Repeat these steps for the Repository and the Agent Datastores.