Cisco Cisco IOS Software Release 12.4(2)XB6 テクニカルリファレンス

To enable sending of vendor specific attributes in subscriber QoS profile based on the PCF, use the cdma 
pdsn pcf ip-address command in global configuration mode. Use the no form of the command to disable 
this feature.

cdma pdsn pcf PCF IP address ending IP address vendor-id NVSE Vendor id

no cdma pdsn pcf PCF IP address ending IP Address vendor-id NVSE Vendor id

The default value is that the home area attribute is not sent to the PCF.

Global configuration

The following example illustrates the cdma pdsn pcf command to configure vendor-id for a set of PCFs:

Router (config)# cdma pdsn pcf 10.1.1.1 10.1.1.50 vendor-id 3729

Single or starting PCF IP address

Ending PCF IP address.

Radius vendor ID of PCF.

12.4(15)XN

This command was introduced.