Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch インストールガイド

• Circuit Overloading—Adding the device to the power outlet must not 

overload that circuit.

Remove the four screws from each side near the front of the switch. 
Retain the screws for re-installation. (Do not remove the four screws 
from each side near the back of the switch.)

Place one of the supplied spacers on the side of the switch so the 
four holes of the spacers align to the screw holes. Place a rack 
mount bracket next to the spacer and reinstall the four screws 
removed in 

.

If your screws are not long enough to reattach the bracket 

with the spacer in place, attach the bracket directly to the case 
without the spacer.

Repeat 

 for the other side of the switch.

After the mounting hardware has been securely attached, the 
switch is now ready to be installed into a standard 19-inch rack.

For stability, load the rack from the bottom to the top, with the 
heaviest devices on the bottom. A top-heavy rack is likely to 
be unstable and might tip over.

181185