Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch ユーザーガイド

To connect the smart switch to the network:

Connect the Ethernet cable to the Ethernet port of a computer, 
printer, network storage, or other network device. 

Connect the other end of the Ethernet cable to one of the 
numbered smart switch Ethernet ports. 

The LED of the port lights if the device connected is active. Refer to 

 for 

details about the different ports and LEDs on each switch.

Repeat 

 for each device you want to connect to 

the smart switch.

Cisco strongly recommends using Cat5 or better cable for Gigabit 

connectivity. When you connect your network devices, do not exceed 
the maximum cabling distance of 100 meters (328 feet). It can take up to 
one minute for attached devices or the LAN to be operational after it is 
connected. This is normal behavior.

The switch is to be connected only to PoE networks without 
routing to the outside plant.

If your switch is one of the Power over Ethernet (PoE) models, consider the 
following power requirement: