Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
Upgrading Existing Housing Seizures
17
3 Using a ½ in. nut driver, install the new seizure screws from the upgrade kit in
the housing.
4 Do one of the following as appropriate:
If the coaxial cable is connected to the housing, tighten each seizure screw
from 2 ft-lb to 5 ft-lb (2.7 Nm to 6.8 Nm).
from 2 ft-lb to 5 ft-lb (2.7 Nm to 6.8 Nm).
If the coaxial cable is not connected to the housing, proceed to To Connect the
Coaxial Cable Pin Connector to the Node Housing (on page 24).
Coaxial Cable Pin Connector to the Node Housing (on page 24).
5 Place the blue stickers on the outside of the housing between the ports to indicate
that the upgrade has been completed.