Canon ir2016, ir2020 マニュアル

3-14

F-3-84

1) Remove the three TP screws (M4 x 12) [1], one RS tightening screw (M3

x 8) [2], and the drive unit [3].

F-3-85

1) Remove the stepped screw [1] (rear side) and RS tightening screw [2]

(front side), and then remove the stay [3] and process tray [4] (right side).

F-3-86

2) Remove the stepped screw [5] (front side) and RS tightening screw [6]

(rear side), and then remove the process tray [7] (left side).

F-3-87

1) Disconnect the connector [1], and then remove the processing tray paper

sensor [2].

F-3-88

1) Remove all connectors from the finisher controller PCB [1], and then open

the two wire saddles [2].

2) Open ten wire saddles[3] and then remove the harnes.

F-3-89

3) Remove two wire saddles[4] behind the finisher controller, and then re-

move the harnes[5].

[5]

[2]

[6]

[4]

[3] [1]

[1]

[2]

[3]

[2]

[4]

[3]

[1]

[7]

[5]

[6]

[1]

[2]

[1]

[2]

[3]

[3]

[3]